To setup port forwarding on this router your computer needs to have a static ip address. Take a look at our Static IP Address guide to setup a static ip address. When you are finished setting up a static ip address, please come back to this page and enter the ip address you setup in the Static IP Address box below.
Open a web browser like internet explorer or Netscape. Enter the ip address of your router in the address bar of your browser. In the picture above the address bar has http://www.google.com in it. Just replace all of that with the ip address of your router. By default the ip address should be set to 192.168.1.1.
You should see a box prompting you for your username and password. Enter your username and password now. By default the username is admin, and the password is 1234. Click the Ok button to log in to your router.
Click the Expert Mode link near the left of the page.
Click the Yes, enter expert mode button near the center of the page.
You should now see a new menu. In this new menu, click NAT.
Click the Define Custom Service button near the center of the page.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. Command and Conquer Zero Hour requires you to forward the 80,6667,28910,29900,29920,4321,27900 ports. Go ahead and enter the settings shown above into the Port Range menu and then click Next.
You should see another page of settings that need to be entered into one of the blank lines on your routers Port Range page. Go ahead and enter those settings and then click Next.
And that is it! You are done!
