Before we can forward ports for UltraVNC, we need to figure out what ports UltraVNC is using. Here is a brief walkthrough on how to do that. Go ahead and open up UltraVNC and get into the Admin Properties.

In the Incoming Connections area you should see a Ports Main and Ports Http boxes. The Ports Main box lets you specify the port that will be used when you use a VNC Viewer to connect to the server. The Ports Http box lets you specify the port that will be used when you use a web browser to connect to the server. If you want to change the ports go ahead and do so. Then enter those ports into the boxes below.

Please enter the port you chose for the Ports Main box into the box below.

To setup port forwarding on this router your computer needs to have a static ip address. Take a look at our Static IP Address guide to setup a static ip address. When you are finished setting up a static ip address, please come back to this page and enter the ip address you setup in the Static IP Address box below.

Open a web browser like internet explorer or Netscape. Enter the ip address of your router in the address bar of your browser. In the picture above the address bar has http://www.google.com in it. Just replace all of that with the ip address of your router. By default the ip address should be set to 192.168.1.1.

You should see a box prompting you for your username and password. Enter your username and password now. By default both the username and password are admin. Click the Ok button to log in to your router.

Please visit our default username and passsword page, if the username and password shown above did not work for you.

Click the Basic link near the left of the page.

Click the New button near the center of the page.

We will list a series of lines here that will show you exactly how to forward the ports you need to forward. UltraVNC requires you to forward the ports you entered above. Go ahead and enter the settings shown above into the NAT menu and then click Submit.

You should see another page of settings that need to be entered into one of the blank lines on your routers NAT page. Go ahead and enter those settings and then click Submit.

You should see another page of settings that need to be entered into one of the blank lines on your routers NAT page. Go ahead and enter those settings and then click Submit.

You should see another page of settings that need to be entered into one of the blank lines on your routers NAT page. Go ahead and enter those settings and then click Submit.

Click the Tools link near the left of the page.

Click the Submit button near the bottom of the page.

Click the Submit button near the bottom of the page.

And that is it! You are done!