Free Help Setting up Your Router or Firewall Set up your router from home
Home Guides Reviews Store Support Forum Requests
see list of routers and firewalls below

Firewalling for the Comodo Firewall






 
Open up the Blockland program.You may see a security alert window that looks like the following image.


If you do, then click the Remember my answer for this application checkbox to put a check in it. Then click the Allow button.Now let's open up the Comodo Firewall so we can check the settings in it.


Click the Security button near the top of the page.




Click the Application Monitor button near the left of the page.




You should see Blockland in the Application Control Rules table. The protocol row of the Blockland should be set to TCP/UDP Out. If it is not set to that click Blockland and then click the Edit button.


In the general section set the Action drop down to Allow. Then set the Protocol drop down to TCP or UDP. Set the Direction drop down to Out. Then click the Ok button to save those settings. Then on the left hand side of the Comodo Firewall window click the Network Monitor option.


We will list a series of lines here that will show you exactly how to setup Comodo Firewall's firewall for Blockland. Go ahead and enter the settings shown below into the Network Control Rule menu.

Click the Add link close to the top of this window. Almost all the settings on the tabs on this page will remain the same. The only one you will need to change is the Destination Port tab. So click that tab now.
  Exclude (i.e. Not the choice below.)  
  Any Ports:  
  A single port  
  A port range  
  A set of ports (comma seperated e.g. 80,443)  
Click the Ok button to save those changes. Once you have created the new rule, be sure to right click that rule and move up above all of the block rules.